Stihl MS 192 T Manual page 69

13. Chain Lubrication
13.1 Pick-up Body
Impurities gradually clog the fine
pores of the filter with minute
particles of dirt. This prevents the oil
pump from supplying sufficient oil to
the bar and chain. Always check the
oil tank and pick-up body first if
problems develop in the oil supply.
Clean the oil tank if necessary.
– Troubleshooting, b 4.3
– Unscrew the oil tank cap and
drain the oil tank.
Collect chain oil in a clean container
or dispose of it properly at an
approved disposal site.
1
: Use hook 5910 893 8800 to pull
the pick-up body (1) out of the oil
tank.
Take care not to overextend the
suction hose.
68
1
– Hold the suction hose with blunt
pliers.
: Pull the pick-up body (1) off the
suction hose.
1
– Flush out the oil tank.
– Replace the pick-up body.
: Push the pick-up body (1) into the
suction hose and place it in the oil
tank.
– Reassemble remaining parts in
reverse order.
13.2 Oil Suction Hose
– Remove the sprocket cover and
bar and chain, b 5.1
– Remove the clutch, b 6.1
– Remove the bumper strips,
b 5.5
– Unscrew the oil tank cap and
drain the oil tank.
– Remove the pick-up body,
b 13.1
: Take out the screws (arrows).
2
: Remove the cover (1), pulling the
worm (2) off the crankshaft stub
at the same time.
1
MS 192 T