Stihl MS 192 T Manual page 44

1
: Disconnect the short circuit
line (1).
: Remove the screw (arrow).
: Disconnect the ground wire (2).
: Remove the screw (arrow).
: Remove the cable guide (arrow).
MS 192 T
1
2
: Remove the ignition module (1)
and cable guide (arrow) for the
ignition lead (2).
– Pull the ignition lead with spark
plug boot out of the engine
housing.
A damaged ignition lead can only be
replaced together with the ignition
module.
– Examine the spark plug boot and
replace it if necessary, b 9.4
– Reassemble parts in reverse
order.
– Moderately tighten the screws on
the ignition module.
: Turn the flywheel until the
magnet pole is lined up with the
ignition module (arrow).
2
: Slide the setting gauge (1)
– Press the ignition module against
– Tighten down the screws.
– Tightening torques, b 3.5
– Reassemble remaining parts in
1
4118 890 6401 between the
arms of the ignition module and
the magnet pole of the flywheel.
the setting gauge.
reverse order.
43