Stihl MS 192 T Manual page 27

2 1
: Pull the spur gear (1) out of the
hole in the cover (2).
: Turn the adjusting screw (arrow)
until the tensioner slide has been
unwound completely.
2 1
: Remove the adjusting screw (1)
from the cover (2).
26
– Clean all disassembled parts with
a little standard solvent-based
degreasant not containing any
chlorinated or halogenated
hydrocarbons. Replace any
damaged or worn parts.
Always replace the adjusting screw
and spur gear together.
– Ensure that the parts are installed
in the correct order.
– Check correct functioning.
– Coat the threads and gear
wheels with STIHL multi-purpose
grease,
b 16
– Reassemble remaining parts in
reverse order.
– Check correct functioning again.
7.3 Bar Mounting Stud
1
– Remove the sprocket cover and
bar and chain, b 5.1
– Fit the stud puller on the collar
stud (1).
1
: Push the stud puller (1)
5910 893 0501 over the collar
stud as far as possible and
unscrew the collar stud
anticlockwise.
– Reassemble parts in reverse
order.
– Fit the collar stud and tighten it
down firmly.
– Tightening torques, b 3.5
– Reassemble remaining parts in
reverse order.
MS 192 T