– Pull the front handle with handle
housing down slightly.
: Pull the bearing plug out of the
engine housing.
1
: Remove the tank vent (1).
1
: Push the fuel return line (1) out.
MS 192 T
2
: Disconnect the tank vent (1) from
the fuel hose (2).
– Draw the fuel hose (2) out
through the opening (arrow).
: Push the grommet (1) out.
1
: Disconnect the impulse hose (1)
from the stub (arrow).
– Remove the handle housing.
1
: Unscrew the spring and bearing
plug.
1
: Screw the spring (1) and bearing
plug (2) into the new front handle.
– Install the complete handle
housing in the reverse sequence
of steps.
– Tightening torques, b 3.5
– Installation of rubber parts is
made easier by using STIHL
Press Fluid, b 16
1
2
67