Stihl MS 192 T Manual page 25

1
2
The forked opening (2) must face
towards the brake band.
: Insert the lever (1) in the side of
the bearing boss (arrow).
2
Ensure that the holes in the lever
inside the hand guard are lined up.
: Slip the bearing boss of the hand
guard (1) and lever (2) onto the
pivot pins.
1
When fitting the parts, ensure that
the cam (arrow) on the hand guard
is guided past the leaf spring.
24
Coat all sliding and bearing points
with STIHL multi-purpose grease,
b 16
Do not grease the brake band.
1
: Attach the brake band (1) to the
brake lever (arrow).
: Insert the brake band (1) in the
opening (arrow).
: The turns of the brake spring
Check correct position of the
protective tube.
1
a = 31 mm
b = 44 mm
1
: Attach the brake spring (1)
must lie tightly against one
another when relaxed. If this is
not the case, replace the brake
spring.
1
to the brake lever (arrow).
MS 192 T