Stihl MS 192 T Manual page 62

11.2 Front Handle / Spring
The spring is located between front
handle and engine housing to
ensure a strong connection
between handle housing and
engine housing without transmitting
vibrations.
– Open the handle housing,
b 12.1
– Remove the throttle trigger and
throttle trigger interlock, b 12.1
– Remove the switch shaft,
b 12.3
: Remove the screw (arrow).
: Remove the screw (arrow) from
underneath the engine housing.
MS 192 T
1
: Pull the front handle (1) out of the
upper guide (arrow).
: Draw the front handle out of the
engine housing with the spring
facing downwards.
1 2
: Examine the front handle (1),
spring (2) and bearing plug (3)
and replace if necessary.
Ensure that the spring (1) has been
fully turned into the front handle and
bearing plug.
– Reassemble parts in reverse
order.
: Slide the front handle into the
hole (arrow), ensuring that the
raised parts of the handle engage
the recess of the handle housing.
3
: Insert and tighten down the screw
(arrow).
– Tightening torques, b 3.5
– Reassemble remaining parts in
reverse order.
1
61