Stihl MS 192 T Manual page 41

2
: Fit the piston pin (2) on the small
diameter of the assembly drift (1)
and slide it into the piston.
: Remove the sleeve (1) from
assembly tool 5910 890 2210.
2
: Attach the snap ring (1) to the
magnet (2) and align it so that the
snap ring gap is on the flat side
(arrow).
40
1
2
: Push the slotted diameter of the
sleeve over the magnet and snap
ring.
The inner pin (1) must point towards
the flat face (2) of the tool's shank.
1
: Press the assembly tool down in
the sleeve until the magnet is at
the end of the guide slits.
Stand the tool on a suitable surface
(wooden board).
1
: Remove the sleeve and push it
as far as possible over the
opposite end of the assembly
tool's shank.
The inner pin must point towards
the flat face.
1
: Apply assembly tool
5910 890 2210 to the piston boss
with the taper sleeve, hold the
piston steady and press the tool
shank home until the snap ring
slips into the groove.
The tool must be precisely aligned
in axial direction of the piston pin.
1
2
The snap ring (1) must be fitted in
such a way that the snap ring gap
(arrow) does not coincide with the
recess (2).
MS 192 T