Stihl MS 192 T Manual page 36

: Pull the oil seals (arrows) off the
crankshaft stubs.
: Carefully pull the crankshaft and
piston out of the cylinder.
MS 192 T
8.5.2 Installation
1
2
– Coat the piston, piston rings and
inside of cylinder with oil.
: Use the clamping strap (1)
1137 893 2600 to compress the
rings around the piston.
The clamping strap (1) must be
fitted so that the arrow (2) points
towards the cylinder exhaust port
and is lined up with the arrow
(arrow) at the bottom of the piston.
– Check that the piston rings have
been installed correctly.
: Align the piston and crankshaft
before inserting them in the
cylinder.
The cylindrical crankshaft stub
(arrow) must point towards the
cylinder exhaust port.
For clarity, the piston is not shown in
this illustration of the clamping strap
fitted in the cylinder.
: Insert the clamping strap with
piston in the cylinder so that the
tab (1) on the clamping strap
engages the correspondingly
shaped recess (arrow).
When sliding the piston into the
cylinder, ensure that the clamping
strap firmly encloses the piston and
that none of the piston rings
protrudes.
– risk of breakage –
– Slide the piston into the cylinder,
the clamping strap moves
backwards at the same time.
: Remove the clamping strap.
1
35