Stihl MS 192 T Manual page 66

– Reassemble parts in reverse
order.
– Tightening torques, b 3.5
– Check correct functioning.
MS 192 T
12.3 Switch Shaft
1
– Remove the handle moulding,
throttle rod, interlock lever and
throttle trigger, b 12.1
: Pull the switch shaft (1) out of the
bearing.
1
: Check the switch shaft – the
metal pin (1) must be firmly
seated in the hole and the cam
(arrow) must be present.
1
3
: Fit the switch shaft (1), pushing
the rear contact spring (3) slightly
to the side.
Check operation
The contact springs are fitted in the
handle housing at different depths.
The rear contact spring (3) and the
front contact spring (2) must make
contact with the metal pin of the
switch shaft when the switch shaft
(1) is in position "0".
– Reassemble remaining parts in
reverse order.
– Tightening torques, b 3.5
– Check correct functioning again.
2
65