Stihl MS 192 T Manual page 56

: Fit the rotor on the starter post so
that the inner loop of the spring
(arrow) enters the recess (1).
The recess in the hub of the rope
rotor acts as carrier for the spring
loop.
– Reassemble remaining parts in
reverse order.
MS 192 T
1
: Position the spring (1) so that the
loop of the spring encloses the
peg of the pawl and the curved
part of the spring (arrow) is
located in the groove in the
starter post.
– Then slide the straight part of the
spring over the starter post until it
engages in the groove.
– Tension the rewind spring,
b 10.6
– Grease the pegs of the pawls,
b 16
10.5 Starter Rope / Grip
– Remove the fan housing,
b 10.2
– Relieve the tension of the rewind
spring and remove the rope rotor,
b 10.4
1
The rewind spring will not be under
tension if the starter rope is broken.
– Remove any remaining scraps of
rope from the rope rotor and
starter grip.
: Tie one of the two special knots
shown above at the end of the
rope in the starter grip.
55