Stihl MS 192 T Manual page 38

: Place the engine pan on the
sealing surface of the cylinder,
ensuring that the lug (arrow)
faces the cylindrical crankshaft
stub (1).
So that the sealing compound is
distributed uniformly, fit the screws
and gently press the engine pan
down.
: Tighten the screws (arrows)
down crosswise.
– Tightening torques, b 3.5
Avoid damage to the crankshaft
stub.
– Clean the crankshaft stub with
standard solvent-based
degreasant not containing any
chlorinated or halogenated
hydrocarbons.
– Install the engine, b 8.4.2
– Reassemble remaining parts in
reverse order.
MS 192 T
8.5.3 Crankshaft / Bearing
– Remove the engine, b 8.4.1
– Remove the crankshaft, b 8.5.1
1
: Remove the ball bearing (1) and
washer.
: Remove the ball bearing (1) and
washer.
3 2
: The crankshaft (1), connecting
rod (2), the needle bearing
between them and the needle
bearing (3) form an inseparable
unit. They must always be
replaced as a complete unit.
The deep groove ball bearings and
oil seals must always be replaced
when installing a new crankshaft.
– Before installing the crankshaft,
clean it with standard solvent-
1
based degreasant not containing
any chlorinated or halogenated
hydrocarbons.
1
: Fit the washer (1).
1
1
37