Stihl MS 192 T Manual page 70

: Pull the hose off the connector
(arrow) on the oil pump.
1
: Pull the suction hose (1) out of
the engine housing.
: Push the smaller diameter of the
new suction hose (1) into the hole
in the engine housing.
MS 192 T
: Use a suitable tool to press in the
suction hose until the groove on
the suction hose is lined up with
the heel on the engine housing.
: Use hook 5910 893 8800 to pull
the suction hose (1) out of the oil
tank.
1
1
: Push the pick-up body (1) into the
suction hose and place it in the oil
tank.
– Reassemble remaining parts in
reverse order.
1
13.3 Oil Pump
Inadequate lubrication of the bar
and chain may be due to the oil
pump if the pick-up body, suction
hose and valve have been checked
and found to be in order.
Remove the sprocket cover and bar
and chain, b 5.1
Remove the clutch, b 6.1
Remove the bumper strips, b 5.5
: Take out the screws (arrows).
2
: Remove the cover (1), pulling the
worm (2) off the crankshaft stub
at the same time.
1
69