Stihl MS 192 T Manual page 64

11.5 Loop
: Remove the screw (arrow).
– Examine the retaining plate and
loop and replace them if
necessary.
: Fit the loop in the retaining plate
(arrow) and position both parts on
the engine housing.
– Insert and tighten down the
screw.
– Tightening torques, b 3.5
MS 192 T
12. Actuating Levers
12.1 Throttle Trigger / Interlock
Lever / Throttle Rod
: Take out the screws (arrows).
: Carefully remove the handle
moulding (1).
Throttle rod and actuating levers
may drop out as the handle
moulding is removed.
1
: Remove the throttle rod (1).
1
: Remove the interlock lever (1)
and throttle trigger (2).
1
: Hook the torsion spring (1) into
the throttle trigger (2).
– note the installed position –
– Examine the torsion spring and
replace it if necessary.
: Place the torsion spring in the
fixture (arrows).
2
1
2
63