Stihl MS 192 T Manual page 34

: Fit the screws (arrows) and
tighten them down only
moderately.
Before tightening the screws down
firmly, the engine must be centred in
relation to the sprocket cover and
guide bar.
: Unscrew the nut (arrow) and
remove the machine from the
assembly stand.
– Fit the guide bar.
MS 192 T
: Guide the peg (arrow) into the
hole and fit the sprocket cover.
: The pin (1) must be lined up with
the hole (arrow) when fitting the
sprocket cover.
1
: Tighten down the nut (arrow) and
secure the sprocket cover (1).
– Now tighten down the screws
securing the engine.
– Tightening torques, b 3.5
– Remove the sprocket cover
again.
– Mount the machine on the
assembly stand again and
continue with the installation
procedure.
1
: Push the manifold (1) onto the
intake stub.
– Coat the manifold with STIHL
Press Fluid, b 16
The tab (arrow) must point towards
the saw chain.
: Press in the supporting plate (1).
1
1
33