5. SERVICE TABLES
Service Table Key
Notation
[range / default / step]
*
1111
DFU
Japan only
LEF
SEF
(!6.2 Image Processing)
SM
What it means
Example: [-9 ~ +9 / +3.0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM
reset, and the value can be changed in 0.1 mm steps with
each key press.
Value stored in NVRAM. After a RAM reset, this default value
(factory setting) is restored.
An SP number set in bold-italics denotes a "Special Service
Program" mode setting. To display the SSPs:
1.
Enter the SP mode.
On the touch panel, press "Copy SP" and together.
2.
Denotes "Design or Factory Use". Do not change this value.
The feature or item is for Japan only. Do not change this
value.
Long Edge Feed
Short Edge Feed
Refer to "6.2 Image Processing" in "6. Details".
Due to fundamental changes in how image processing
adjustment is done with Group 4 SP codes, more details are
provided in Section 6.
13
COPY SP SERVICE TABLES
B692/B694