Stapling Position - Ricoh Aficio 2035e Service Manual

3.2.3 STAPLING POSITION

290 ± 2 mm (A4Y), 273 ± 2 mm (LTR)
Staple
Rear Front
SW2 SW1
After replacing the finisher board, do this adjustment. Doing this adjustment will
affect all paper sizes and all stapling positions.
1. Remove the upper rear cover.
2. Turn on dip switches 3 -1 and -2 on the finisher board.
3. Press the following switch on the finisher board.
Using A4: Switch 1 (SW1)
Using 8 " x 11": Switch 2 (SW2)
1/2
• After pressing the switch, the upper exit unit will open and the transport belt
will rotate.
4. Within five seconds after pressing the switch, place one sheet of A4/8
paper between the jogger fences and push it until it touches the shutter.
When the staple tray paper sensor detects the paper, the stapler will staple
(rear, 1 point).
5. Take out the stapled paper manually and check the staple position.
Staple position: Good → Turn off dip switches 3 -1 and -2 to end the
Staple position: No good → Change the staple position by doing the
6. Adjust the staple position by pressing switch 1 or 2.
Switch 1: Move the front (0.3 mm/press)
Switch 2: Move to the rear (0.3 mm/press)
7. Press switches 1 and 2 simultaneously to store the adjustment data. After
pressing the switches, check the staple position again.
8. Turn off dip switches 3 -1 and -2, then turn off the copier main switch.
SM
R555.WMF
procedure.
following steps.
41
ADJUSTMENT
Dip Switch 3
ON
1 2 3 4 5 6 7 8
R554.WMF
" x 11"
1/2
B546