3.2 ADJUSTMENT
3.2.1 SHIFT TRAY HEIGHT
After replacing the finisher board or shift tray height sensor, always do this
adjustment.
1. Remove the upper rear cover.
2. Turn on dip switches 3 -1 and -4 on the finisher board.
3. Put blank paper (A4/8
4. Press switch 1 (SW1) on the finisher board.
The finisher automatically adjusts the shift tray height when switch 1 is pressed.
• After performing the adjustment, the shift tray will return to home position.
• During the adjustment, LED 1 flashes. After performing the adjustment, LED
1 turns on and remains on.
• If the automatic adjustment fails, the finisher stops and LED 1 turns off.
5. Turn off dip switches 3 -1 and -4, then turn off the copier main switch.
SM
SW1
SW2
Dip Switch 3
"
11") on the shift tray.
1/2
x
39
LED 1
LED 2
R550.WMF
Dip Switch 3
ON
1
2 3
4
5 6 7 8
R551.WMF
ADJUSTMENT
B546