Ricoh Aficio 2035e Service Manual page 749

System Switch 04
No FUNCTION
3 Printing dedicated tx
parameters on Quick/Speed
Dial Lists
0: Disabled
1: Enabled
4-7 Not used
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09
No FUNCTION
0 Addition of image data from
confidential transmissions on
the transmission result report
0: Disabled 1: Enabled
1 Inclusion of communications on
the Journal when no image
data was exchanged.
0: Disabled 1: Enabled
2 Automatic error report printout
0: Disabled 1: Enabled
3 Printing of the error code on the
error report
0: No 1: Yes
4 Not used
5 Power failure report
0: Disabled 1: Enabled
6 Conditions for printing the
protocol dump list
0: Print for all communications
1: Print only when there is a
communication error
7 Priority given to various types
of remote terminal ID when
printing reports
0: RTI > CSI > Dial label > Tel.
number
1: Dial label > Tel. number >
RTI > CSI
SM
COMMENTS
1: Each Quick/Speed dial number on the list is
printed with the dedicated tx parameters (10 bytes
each).
The first 10 bytes of data are the programmed
dedicated tx parameters; 34 bytes of data are
printed (the other 24 bytes have no use for service
technicians).
Do not change the settings.
COMMENTS
If this feature is enabled, the top half of the first
page of confidential messages will be printed on
transmission result reports.
0: Communications that reached phase C (message
tx/rx) of the T.30 protocol are listed on the Journal.
1: Communications that reached phase A (call
setup) of T.30 protocol are listed on the Journal.
This will include telephone calls.
0: Error reports will not be printed.
1: Error reports will be printed automatically after
failed communications.
1: Error codes are printed on the error reports.
Do not change the setting.
1: A power failure report will be automatically printed
after the power is switched on if a fax message
disappeared from the memory when the power was
turned off last.
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol
dump list only for communications with errors.
This bit determines which set of priorities the
machine uses when listing remote terminal names
on reports.
Dial Label: The name stored, by the user, for the
Quick/Speed Dial number.
27
BIT SWITCHES
SP No. 1-101-005
SP No. 1-101-010
B653