Ricoh Aficio 2035e Service Manual page 251

5821* Remote Service
Address
5821 1* CSS PI Device Code
5821 2* RCG IP Address
5824 NVRAM Data Upload
Uploads the UP and SP mode data (except for counters and the serial number)
from NVRAM on the control board to a flash memory card.
While using this SP mode, always keep the front cover open. This prevents a
software module accessing the NVRAM during the upload.
5825 NVRAM Data Download
Downloads the content of a flash memory card to the NVRAM on the control
board.
5828* Network Setting
5828 66* Job Spooling
Clear: Start Time
5828 69* Job Spooling:
Protocol
5828 74* Delete Password
5828 84* Print Settings List
5828 90* TELNET (0:OFF
1:ON)
5828 91* Web (0:OFF
1:ON)
SM
Japan Only.
Sets the PI device code. After changing this setting,
you must switch the machine off and on.
Sets the IP address of the RCG (Remote
Communication Gate) destination for call processing at
the remote service center.
[00000000h ~ FFFFFFFFh/ 00000000h /
Determines whether unprinted jobs on the HDD are printed
the next time the machine is switched on. Available only the
job spooling feature.
ON: Clear spooled jobs from HDD at power on.
OFF: Print spooled jobs on HDD at power on.
Disables and enables protocols used for job spooling. The
settings are done by entering a "0" (Off) or a "1" for each bit
switch. Defaults: 1 (all enabled).
Bit Protocol Comments
0 LPR
1 FTP Not used
2 IPP
3 SMB
4 BM Links Japan Only
5 Reserved Not used
6 Reserved Not used
7 Reserved Not used
Deletes the NCS (Network Control Service) password. Sets
the Telnet, WSM (Web Status Monitor), and remote ROM
update passwords to NULL (empty)
Prints a list of the NCS parameter settings.
Disables or enables Telnet operation. If this SP is disabled
the Telnet port is closed.
[0~1/ 1 / 1]
0: Disable
1: Enable
Disables or enables the Web operation.
[0~1/ 1 / 1]
0: Disable
1: Enable
5-35
SERVICE PROGRAM MODE
B135/B138