Ricoh Aficio 2035e Service Manual page 679

UP Mode Settings for IEEE 1394
Enter the UP mode and follow the procedure below to perform the initial interface
settings for IEEE 1394. These settings take effect every time the machine is
powered on.
1. Press User Tools/Counter.
2. On the touch panel, press System Settings.
3. Press Interface Settings.
4. Press the key and enter the following settings:
• IP Address
• Subnet Mask
• IP Over 1394. Enable or disable this setting as required. This setting enables
IP Over 1394 as the default setting for the printing method.
• SCSI Print. Enable or disable this setting as required. This setting enables
SCSI Print as the default setting for the printing method.
• SCSI Print Bi-directional. Switch bi-directional printing on or off for SCSI print.
SP Mode Settings for IEEE 1394
The following SP commands can be set for IEEE 1394.
SP No. Name
5839 004 Device Name
5839 007 Cycle Master
5839 008 BCR Mode
5839 009 IRM 1394a
Check
5839 010 Unique ID
5839 011 Logout
5839 012 Login
5839 013 Login MAX
SM
Function
Sets the names for all the physical devices connected to
the IEEE 1394 firewire network.
Enables or disables cycle master function of the IEEE
1394 standard bus.
Sets the BCR (Broadcast Channel Register) setting for
the Auto Node operation for the standard IEEE1394 bus
for when IRM is not in use. Three settings are available:
00, 01, 11.
Determines whether an IRM check for IEEE 1394 is
conducted for the Auto Node when IRM is not used.
Enables the "Node_Unique_Id" setting for enumeration
on the standard IEEE 1394 bus.
Determines how successive initiator login in requests
are handled during login in for SBP-2.
Enables or disables exclusive login for SBP-2.
Sets the limit for the number of logins for SBP-2. Range:
1 ~ 62.
11
IEEE 1394 FIREWIRE (G336)
B654