Advertisement
E.
Adjusting the Overlap of
the Sensor Flag
Normally, position any machine parts to
the initial graduations shown in Figure 3-312.
If the overlap between the sensor and the flag
is wrong for some reason, perform the
following:
1) Remove the processing tray unit. (Figures
3-301 through -306)
2) Loosen the mounting screw [2] of the
front/rear jogging plate adjusting plate
[1]; then, move the adjusting plate left and
right.
3) Tighten the screw so that the overlap
between the flag of the front/rear jogging
rack plate and the sensor is 1.5 to 2.0 mm.
COPYRIGHT © 1999 CANON INC.
CANON FINISHER-E1 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
[1]
[2]
[3]
[2]
Figure 3-318
Sensor
1.5 to 2.0mm
Figure 3-319
[1]
[3]
Sensor flag
3-15
Advertisement
Chapters
