Canon FINISJER-E1 Service Manual page 133

E. Adjusting the Tension of
the Stack Tray Drive Unit
1) Remove the inside right cover.
2) Remove the stack tray lifter motor clock
sensor support plate. (Figure 3-610)
3) Remove the stack tray drive unit. (Figure
3-611)
4) Loosen the adjusting screw [2] of the
tension arm [1]. (At this time, the tension
arm must be under pressure.)
5) When the tension arm [1] is back at its
initial position, tighten the adjusting
screw [2].
COPYRIGHT © 1999 CANON INC. CANON FINISHER-E1 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 5 TROUBLESHOOTING
[1]
[1] [2]
Figure 5-118
[1]
[1] [2]
Figure 5-119
[2]
[2]
5-9