Canon FINISJER-E1 Service Manual page 95

D. Adjusting the Angle of
the Jogging Plate
1) Without removing the processing tray
unit, loosen the two mounting screws [2]
of the rear jogging plate.
2) Place several sheets of A4/LTR paper on
the processing tray, and adjust the rear
jogging plate. (At this time, adjust the gap
between the paper and the front end of the
rear jogging plate so that it is 0 to 0.5
mm.)
COPYRIGHT © 1999 CANON INC. CANON FINISHER-E1 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
[1]
[2]
Figure 3-314
Paper
Butted.
Finisher body
Figure 3-315
0 to 0.5mm
Screws
Rear jogging
plate
3-13