Advertisement
2.
Stapling Unit
The motors and sensors associated with the stapler are as follows:
Notation
Name
M6
Stapler motor
S14
Stapler safety sensor
S15
Stapler edging sensor
S16
Staple sensor
S17
Stapling home position
sensor
S18
Stapler cartridge sensor
The stapler safety sensor (S14) is used to cut off power to the stapler motor in the event that a
finger or the like is found in the stapler assembly.
Caution:
If staple mode is selected on the control panel with paper on the stack tray, the copier will be
ready for copying while prompting the removal of paper.
If the Copy Start key is pressed without removing the paper, the paper may not be put into order
or stapled correctly.
COPYRIGHT © 1999 CANON INC.
SW/PI
–
Used to punch staples into sheets.
SW
Used to protect the user.
SW
Used to find out if the stapler unit
is at a position for stapling. If not,
causes the stapler to execute idle
punching to enable stapling.
PI
Used to detect the staples reaming
in the cartridge.
PI
Used to detect the home position
for stapling.
SW
Used to find out whether a
cartridge is set inside the stapler
unit.
Table 2-502
CANON FINISHER-E1 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 2 BASIC OPERATION
Description
Remarks
Inside the stapler unit
Inside the stapler unit
Inside the stapler unit
Inside the stapler unit
Inside the staple unit
Inside the stapler unit
SW: Microswitch
PI:
Photointerrupter
2-43
Advertisement
Chapters
