C.
Adjusting the Tension of
the Stack Tray Drive Unit
1) Remove the inside right cover.
2) Remove the stack tray lifter motor clock
sensor support plate. (Figure 3-610)
3) Remove the stack tray drive unit. (Figure
3-611)
4) Loosen the adjusting screw [2] of the
tension arm [1]. (At this time, the tension
arm must be under pressure.)
5) When the tension arm [1] is back at its
initial position, tighten the adjusting
screw [2].
COPYRIGHT © 1999 CANON INC.
CANON FINISHER-E1 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
[1]
[1]
[2]
Figure 3-612
[1]
[1]
[2]
Figure 3-613
[2]
[2]
3-31