Canon FINISJER-E1 Service Manual page 130

CHAPTER 5 TROUBLESHOOTING
D. Adjust the Tension of the
Stack Processing Motor
Belt
1) Remove the inside right cover and the rear
cover. (Figure 3-103)
2
2) Using 64 g/m paper, prepare a sheet of
about 10 x 200 mm; then, fold it in four.
3) Turn the motor spindle [1] so that the
sheet [4] is between the belt [2] and the
tension roller [3].
5-6
COPYRIGHT © 1999 CANON INC.
50mm
Figure 5-113
[1]
[4]
Figure 5-114
CANON FINISHER-E1 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
10mm
[2]
[3]