Canon FINISJER-E1 Service Manual page 112

CHAPTER 3 MECHANICAL SYSTEM
B. Removing the Stack Tray
Drive Unit
1) Remove the inside right cover and the rear
cover. (Figure 3-103)
2) Remove the stapler cover.
3) Remove the mounting screw [1], and
detach the stack tray lifter motor clock
sensor support plate [2].
4) Remove the three mounting screws [3],
and disconnect the connector [4]; then,
detach the stack tray drive unit [5].
3-30
COPYRIGHT © 1999 CANON INC.
[2]
Figure 3-610
[3]
[5]
Figure 3-611
CANON FINISHER-E1 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
[3] [4]