Honda CRF450R 2009 Service Manual page 453

Be careful not to
damage the brake
pad,
Pack the lips of a new dust seal with grease, and install
it to the wheel hub.
Install the brake disc onlo lhe wheel hub with the
minimum thickness mark (MIN . TH . 3.5 mm) facing out.
Install the bolts/nuts.
Tighten the nuts to the specified torque.
TORQUE : 16 N' m (1 .6 kgf' m, 12Ibf·ft)
REAR WHEEUSUSPENSION
Check the right and left side collars for wear or
damage' 1~~~~~~~;~~~~~~:~;~
Replace them
if
necessary.
~
Install the right and left side collars.
INSTALLATION
Place the rear wheel into the swingarm carefully r:":::'~;;-;:~~--:;
aligning the brake disc between the brake pads.
Install the drive chain over the driven sprocket.
Apply a thin coat of grease to the axle shaft sliding
surface .
Install the adjusting blocks and axle shaft from the left
side .
Install the washer and axle nul.
Adjust the drive chain slack (page 4-23).
15-13