Honda CRF450R 2009 Service Manual page 200

FUEL SYSTEM (PGM·FI)
V9, ' 10:
Install the throttle body by aligning its lab with the
insulator groove.
Align the insulator
Tighten the insulator band screw as shown .
band hole with
the
Insulator lab.
After '10. '
Install the throttle body by aligning its tab With the
insulator groove.
AJrgn the insulator
Tighten the insulator band screw as shown.
band
hole
with the
insula/or tab.
6-68
Install the rear shock absorber upper mounting bolt by
aligning cut-outs of the frame and upper mounting bolt.
Install and tighten the rear shock absorber upper
mounting nut to the specified torque.
TORQUE : 44 N'm (4.5 kgf' m, 321bHt)
Route the wire harness and hoses properly
(page 1 ~23).
Connect the fuel injector 2P (Gray) and MAP sensor 3P
(Black) connectors.
Connecllhe quick connect fitting to the fuel injector joint
(page 6-46).
THROTIlE BODY
12 ± 1 mm
(0.5 ± 0.04 in)
'11 -' 12:
a
AIiBn
<'
11±lmm
(0.4 ± 0.04 in)
AFTER '12:
G. - Align
O , , ± , m m
~
4
(0.4 ± 0.04 In)