Delta Electronics AC Servo Drive ASDA-AB User Manual page 46

DI
DI
Code
Signal
JOGU 37
JOGD 38
STEPU 39
STEPD 40
STEPB 41
AUTOR 42
GNUM0 43
GNUM1 44
INHP 45
Footnote *2: The "state" of the input function may be turned ON or OFF as it will be dependant on the
settings of P2-10~P2-17.
Revision January 2009
Assigned
Pin No.
Control
(Default)
Mode
Forward JOG input. When JOGU is
Not
- activated, the motor will JOG in forward
assigned
direction. [see P4-05]
Reverse JOG input. When JOGD is
Not
- activated, the motor will JOG in reverse
assigned
direction. [see P4-05]
Not Step up input. When STEPU is activated,
-
assigned the motor will run to next position.
Step down input. When STEPD is
Not
- activated, the motor will run to previous
assigned
position.
Step back input. When STEPB is
Not
- activated, the motor will return to first
assigned
position.
Auto run input. When AUTOR is activated,
the motor will run automatically according
Not
- to internal position command. For time
assigned
interval setting, please see P2-52 to P2-
59.
Not Electronic gear ratio (Numerator) selection
-
assigned 0 [See P2-60~P2-62]
Not Electronic gear ratio (Numerator) selection
-
assigned 1 [See P2-60~P2-62]
Pulse inhibit input. When the drive is in
Not
- position mode, if INHP is activated, the
assigned
external pulse input command is not valid.
Chapter 3 Connections and Wiring|ASDA-AB Series
(*2)
Details
Wiring Diagram
(Refer to 3-3-3)
C9/C10
3-21