Configure The Ftp Server Feature; Configure The Upnp - Zte H3140 Maintenance Management Manual

H3140 Maintenance Management Guide

5.5 Configure the FTP Server Feature

Abstract
This procedure describes how to enable the
FTP parameters, including the username and password.
Steps
1. In the left navigation tree, click Local Network > FTP. The FTP Application page is
displayed, see
Figure 5-24 FTP Page
2. Set the parameters. For a description of the parameters, refer to
Table 5-18 FTP Server Parameter Descriptions
Parameter
Server
FTP Username/FTP Pass-
word
3. Click On to enable the FTP server feature, and click Apply button to apply the
changes.

5.6 Configure the UPnP

Abstract
The UPnP
matic discovery of vendor device types. After the UPnP function is configured, a device
can dynamically join a network to obtain its IP address, report its functions, and learn
about the functions of other devices.
Steps
Enable or Disable the UPnP Function
62
Figure 5-24.
Description
Enable or disable the FTP server feature .
Username and password used to connect to the FTP server.Valid
only if FTP security control is enabled.
function is used to support zero configuration, invisible networking, and auto-
FTP feature of the H3140 by configuring
SJ-20210621164956-009 | 2021-12-07(R1.0)
Table 5-18.