Zte H3140 Maintenance Management Manual page 37

Figure 4-15 Service Control-IPv4 Page
3. Configure the service control-IPv4 parameters.
Table 4-10
Table 4-10 Parameter Descriptions for the Service Control-IPv4
Parameter
On/Off
Name
Target
Ingress
IP Range
Service Type
4. Click Apply button to apply the changes.
Configure the Service Control-IPv6
5. Click Service Control-IPv6 to open Service Control-IPv6 page, see
SJ-20210621164956-009 | 2021-12-07(R1.0)
lists the local service control-IPv4 parameters.
Description
Click On to enable the function.
Click Off to disable the function.
Name of the service control item.The name must be specified.
Specify to discard or permit the data packages.
Specify the data stream inbound direction, and this parameter
must be specified.
If the Ingress is WAN_All, all the WAN connection can access

H3140.
If the Ingress is LAN, the LAN side can access H3140.

If the Ingress is a WAN or Route_3G connection, the connec-

tion selected can access H3140.
The IP address segment that needs to be filtered.
When the IP segment is null, it refers to all the IP addresses.
Specify the service that is permitted or denied to access.
4 Configure the Internet
Figure 4-16.
31