Zte H3140 Maintenance Management Manual page 27

Steps Operation
2 Check the 3G device status.
3 Create a 3G WAN connec-
tion.
4 Check the 3G connection sta-
tus.
Note
What to do when 3G device is not ready?
1. Check whether the dongle is plugged in.
2. If the device is already plugged in, please check whether the USB is contacted well.
3. If the device is still unrecognized, maybe it has been damaged. Please replace the
device.
Steps
1. Insert 3G device.
2. On the main page of the H3140, select Internet > WAN > 3G > Mobile Network
to the Mobile Network page. The signal strength can verify the network card is
plugged, see
Figure 4-6 Mobile Network
3. Click Refresh to refresh the information.
4. On the main page of the H3140, select Internet > WAN > 3G to the 3G Connection
page.
Table 4-3
page , see
SJ-20210621164956-009 | 2021-12-07(R1.0)
Figure 4-6.
lists the New Item parameter. After the setup is complete, you can see the
Figure 4-7.
Instructions
The signal strength can verify whether the network card is
plugged.
Click
3G connection.
The IP address getting from carries can verify that the 3G
WAN Connection based on IPv4 was completed successfully.
4 Configure the Internet
on the page, and create a new
21