Login - Zte H3140 Maintenance Management Manual

2. On the local computer, double-click Local Area Connection and click Properties.
The Local Area Connection Properties dialog box is displayed.
3. Double-click Internet Protocol (TCP/IP). The Internet Protocol (TCP/IP) Proper-
ties dialog box is displayed. Set the IP address to 192.168.1.200, subnet mask to
255.255.255.0, and default gateway to 192.168.1.1.
4. Click OK.
Postrequisite
After setting the IP address of the computer, you can run the Ping command to ping the
IP address 192.168.1.1. If the ping operation is successful, it indicates that the TCP/IP
configuration is correct and the computer is properly connected to the H3140.

3.2 Login

Abstract
The H3140 provides a Web-based configuration and management system. You can en-
ter a specified IP address in the address bar of Internet explorer to access the system.
Prerequisite
A computer is directly connected to the H3140, and their IP addresses are in the same
network segment.
Steps
1. Open Internet explorer, and enter http://192.168.1.1 (default maintenance IP address
of the H3140) in the address field. Press the Enter key. The login page is displayed,
see Figure
SJ-20210621164956-009 | 2021-12-07(R1.0)
3-1.
3 Configuration Preparation
13