Canon GALVANO GC-251 User Manual page 60

Command ID
Parameter ID
Data
0: Command execution successful
Return
1: Command execution unsuccessful
Value
This command returns the parameter setting of Parameter ID.
Explanation
Command ID
0: Z phase
Data
1: Program Origin
0: Command execution successful
Return
1: Command execution unsuccessful
Value
For a raster scan, the center of the oscillation angle can be changed.
Explanation
0: Z phase
1: Program Origin
Command ID
0: Encoder Head1 A phase
Data
1: Encoder Head2 A phase
2: Corrected A phase
3: Position error
0: Command execution successful
Return
1: Command execution unsuccessful
Value
The output signal of analog monitor output A2 (the Axis1) and A8 (the Axis2) can be
Explanation
selected.
When the controller starts, the 3: Position error has been selected.
(For details, see 5.2, "Analog Monitor Output Selecting ")
Command ID = 44: Monitor Magnification Setting (A2, A8 )
Related
Command
CANON Digital Galvano Scanner System KP-1SM Series + GC-251
Users Manual 1.00
26
30
Set the Z-phase position as the center. This setting is in the default after activation.
Set the current position as the center.
When setting the program origin, move once to the desired center and then specify the
position by this command.
40
Command
Parameter Value Check
Name
Command
Program Coordinate System
Name
Command
Monitor Output Selection (A2, A8)
Name
60