Section 4; Brewer System; Replacing The Brewer Assembly - Keurig Eccellenza Momentum Service Manual

Brewer System

Replacing the Brewer Assembly

1. Remove the waste bin and open the front door.
2. Remove the brewer spout assembly.
3. Press on the bottom of the red release latch, and rotate the brewer towards the left
(clockwise) to release it.
4. Lift the brewer off the brewer motor to remove it.
If you are performing the annual maintenance on the brewer, continue with
this section of the manual for instructions to completely disassemble the
brewer.
To install the brewer, follow these same instructions in the reverse order.
When re-installing the brewer, make certain the wiper is properly installed
inside of the wiper arm.
VKI Publication #202378-001
Eccellenza Momentum™
S
E C T I O N
4
25