Every 3 Years - Technician; Miscellaneous - Keurig Eccellenza Momentum Service Manual

Service Manual

Every 3 Years - Technician

Miscellaneous

10
► Replace Brewer Seals and Gaskets - there are several seals and gaskets located
throughout the brewer assembly that need to be replaced every 12 months or
15,000 cycles. The brewer 'Yearly Maintenance Kit' (p/n - 202341-003) contains
everything required.
► Inspect Electrical Wiring and Components - inspect all of the equipment wiring,
terminals, connectors and electrical components (valves, motors, relays, element, etc.) for
signs of wear, damage or overheating at connection points. Replace them, if required.
► Replace the following: heater element, thermal cut-off switch and external relay,
all seals and gaskets and o-rings.
► Run the Brewer Rinse and/or Mixers Rinse Cycles when prompted by the machine
(a message appears on the touch screen).
► Run the Brewer Cleaning cycle using the Urnex TABZ Z61 cleaning tablets – see the
Momentum™ Operation Manual (VKI Publication #202377-001) for more details.
► Run the Grinder Cleaning cycle using the Urnex SuperGrindz A01 cleaning pellets –
see the Momentum™ Operation Manual (VKI Publication #202377-001) for more
details.
► Verify Water Tank Components - dependent on the local water condition - inspect,
clean or replace components, as required.
► Clean the Side Exhaust Fan - over time, dust will accumulate on the exhaust fan on
the right side wall and it must be cleaned to maintain the fan's performance.
► Cleaning the Coffee Dispenser - empty, remove, and clean the coffee dispenser
with warm water and dish soap. Thoroughly dry the dispenser before re-installing
it. For detailed information about removing the coffee dispenser, go to
► Cleaning the Powder Dispensers - empty, remove, and clean the powder
dispensers with warm water and dish soap. Thoroughly dry the dispensers before
re-installing them. For detailed information about removing the powder
dispensers, go to page
► Inspect the grinder – to prevent the grinder from jamming, re-adjust the grinder
heads if the coffee grounds are too fine, and keep the grinder chute clean –
Failure to perform the required care and maintenance will result in poor
beverage quality and will lead to equipment malfunctions. It may also void
any remaining warranty on the equipment and its components.
39.
page 37.
page 38.
VKI Publication #202378-001