Secondary Power Switch (Service Switch)
1.
Remove the coffee dispenser (see
2.
Remove the two screws securing the secondary switch plate to the machine.
3.
Disconnect the wiring from the power switch.
4.
Compress the clips on each side of the switch, and push it through the opening in the
metal plate (towards the outside).
5.
Insert the new switch into the cut-out of the metal plate, and snap it in place to secure
it - make sure the 'O' it towards the bottom and the '—' is towards the top.
6.
Connect the wiring to the new power switch.
i. Tab #2 on switch - black wire (hot).
ii. Tab #1 on switch - white wire (neutral).
iii. Tab #2a on switch - black wire with yellow insulator
iv. Tab #1a on switch - black wire with yellow insulator
7.
Re-install the secondary switch plate and secure it in place with two screws.
VKI Publication #202378-001
page
37).
Eccellenza Momentum™
61