Fault Codes - Keurig Eccellenza Momentum Service Manual

Fault Codes

Should a fault be present, it is identified in the "Current Status" tab, under the "System Status"
menu, using one of the codes from the list below. The right section of the screen shows the
component code (and pending component codes) and a brief description of the fault.
CODE
B1 Blower (Powders)
D1 Tank Overflow Detection
D2 Waste Bin Presence Detection
D6 Cup Detection
G1 Grinder
H1 Heating Element
K1 Exhaust Fan
L4 Normal Water Level Detection
L5 Safety Water Level Detection
L9 Waste Bin Level Detection
M1 Powder 1 Motor
M2 Powder 2 Motor
M3 Powder 3 Motor
M4 Powder 1 Whipper Motor
M5 Powder 3 Whipper Motor
M6 Coffee 1 Motor
In the example above, a fault has been detected with "G1", which is the grinder. After correcting the
error, tap the "Clear All" button. The screen then displays a green checkmark with the "System is
running perfectly" message beneath it. In some cases, the error may re-appear when the machine is
placed back in normal operation, at which point a more thorough troubleshooting is required.
Fault codes must be manually cleared (in this menu) after the fault has been
corrected, otherwise the error message will continue to appear on the main
screen.
VKI Publication #202378-001
COMPONENT CODE COMPONENT
M7 Coffee 2 Motor
M8 Coffee 3 Motor
M9 Brewer Motor
M10 Brewer Wiper Motor
M11 Powder 2 Whipper Motor
S1 Cup Lighting
S2 Esthetic Lighting
T1 Temperature Probe
V1 Outlet Valve - Coffee
V2 Outlet Valve - Powder 3
V3 Outlet Valve - Powder 1
V4 Outlet Valve - Hot Water
V5 Inlet Valve
V6 Outlet Valve - Powder 2
MBD1 Coin Acceptor
MDB3 Card Reader
Eccellenza Momentum™
21