Replacing The Outlet Valve(S) - Keurig Eccellenza Momentum Service Manual

Service Manual

Replacing the Outlet Valve(s)

1.
2.
3.
4.
5.
6.
7.
8.
9.
54
With the water tank drained and the service cord disconnected, remove the three
powder dispensers (see page
Loosen the lower screw and remove the upper screw securing the valve cover in place.
Once done, lift the valve cover to remove it.
Disconnect the outlet hose and disconnect the wiring from the valve(s) to be removed.
To remove a valve, grasp the valve body and pull it straight out. You may need to twist
it slightly to loosen it. Caution: There may be a small amount of very hot water that
spills when a valve is removed!
Install the new valve by sliding it into its respective port on the water tank.
Verify that the o-ring is present on the valve before installing it into the tank.
Also make sure that the valve is completely seated into the water tank.
Connect the outlet hose and connect the power wires onto the replacement valve.
Re-install the valve cover, the powder dispensers, trim and individual covers.
Reconnect the service cord, turn on the water supply, and switch the machine power on.
Allow the water tank to fill and inspect the machine for leaks. Also inspect the outlet
valve for any signs of dripping.
corrected immediately.
41).
If any leaks or dripping is present, the problem must be

= Powder 1

= Powder 2

= Powder 3

= Hot Water

= Coffee*
*
has a larger diameter
opening than the other
four valves
VKI Publication #202378-001