Connecting The Power Cord - Canon MultiPASS C70 User Manual

Connecting the Power Cord

c
Follow these guidelines when connecting your MultiPASS C70 to a
power source:
The MultiPASS C70 is intended for domestic use only and requires
200–240 V AC. Do not use it outside the country for which it is
intended.
Only plug the unit into a 200–240-volt AC 50–60 Hz, three-prong
grounded outlet.
Use only the power cord that came with the unit. Using a longer
cord or extension cord can cause the unit to malfunction.
Unplug the unit only by pulling on the plug itself. Never pull on
the cord.
The MultiPASS C70 is equipped with a three-prong, grounding-
type plug provided with a third (grounding) pin. This plug will
only fit into a grounding-type outlet. This is a safety feature. If you
are unable to insert the plug into your outlet, contact an electrician
to replace your outlet. Do not defeat the safety purpose of the
grounding-type plug by breaking off the third prong or using a 3-
to-2 adaptor.*
Do not plug the MultiPASS C70 into the same circuit as an
appliance such as an air conditioner, electric typewriter, television,
or copier. Such devices generate electrical noise that can interfere
with your MultiPASS C70's ability to send and receive faxes.
Do not allow anything to rest on the power cord, and do not locate
the unit where the cord will be walked on. Make sure the cord is
not knotted or kinked.
Make sure that the total ampere rating of all products plugged into
the wall outlet does not exceed the current amperage of the circuit
breaker.
Make sure the operation panel of the MultiPASS C70 is properly
closed, and that there are no documents in this area.
* The shape of the plug varies depending on the country of purchase.
2-20
Setting Up Your MultiPASS C70 Chapter 2