Routing Table (Transparent Mode); Routing Table List; Transparent Mode Route Settings - Fortinet FortiGate FortiGate-60M Administration Manual

Routing table (Transparent Mode)

Routing table (Transparent Mode)

Routing table list

Transparent mode route settings

60
In Transparent mode, you can configure routing to add static routes from the
FortiGate unit to local routers.
Figure 12: Routing table
Create New Select Create New to add a new route.
# Route number.
IP The destination IP address for this route.
Mask The netmask for this route.
Gateway The IP address of the next hop router to which this route directs traffic.
Distance The the relative preferability of this route. 1 is most preferred.
Delete icon. Select to remove a route.
View/edit icon. Select to view or edit a route.
Move To icon. Select to change the order of a route in the list.
Figure 13: Transparent mode route options
Destination IP Enter the destination IP address and netmask for this route.
/Mask
Gateway Enter the IP address of the next hop router to which this route directs traffic
Distance The the relative preferability of this route. 1 is most preferred.
To add a Transparent mode route
1 Go to System > Network > Routing Table.
2 Select Create New to add a new route.
3 Set the Destination IP and Mask to 0.0.0.0.
For the default route, set the Destination IP and Mask to 0.0.0.0.
Note: Only one default route can be active at a time. If two default routes are added to the
routing table, only the default route closest to the top of the routing table is active.
01-28007-0144-20041217
System network
Fortinet Inc.