Fortinet FortiGate FortiGate-60M Administration Manual page 31
Version 2.80 mr7 antivirus firewalls
Hide thumbs
Also See for FortiGate FortiGate-60M:
- Quick start manual (2 pages) ,
- Installation manual (64 pages)
Table of Contents
Advertisement
System status
FortiGate-60M Administration Guide
3
In the Attack Definitions field of the Unit Information section, select Update.
The Intrusion Detection System Definitions Update dialog box appears.
4
In the Update File field, type the path and filename for the attack definitions update
file, or select Browse and locate the attack definitions update file.
5
Select OK to copy the attack definitions update file to the FortiGate unit.
The FortiGate unit updates the attack definitions. This takes about 1 minute.
6
Go to System > Status > Status to confirm that the Attack Definitions Version
information has updated.
To change to Transparent mode
After you change the FortiGate unit from the NAT/Route mode to Transparent mode,
most of the configuration resets to Transparent mode factory defaults, except for HA
settings (see
"HA" on page
To change to Transparent mode:
1
Go to System > Status > Status.
2
In the Operation Mode field of the Unit Information section, select Change.
3
In the Operation Mode field, select Transparent.
4
Select OK.
The FortiGate unit changes operation mode.
5
To reconnect to the web-based manager, connect to the interface configured for
Transparent mode management access and browse to https:// followed by the
Transparent mode management IP address.
By default in Transparent mode, you can connect to the internal interface. The default
Transparent mode management IP address is 10.10.10.1.
Note: If the web-based manager IP address was on a different subnet in NAT/Route mode, you
may have to change the IP address of your computer to the same subnet as the management
IP address.
To change to NAT/Route mode
After you change the FortiGate unit from the NAT/Route mode to Transparent mode,
most of the configuration resets to Transparent mode factory defaults, except for HA
settings (see
"HA" on page
To change to NAT/Route mode:
1
Go to System > Status > Status.
2
In the Operation Mode field of the Unit Information section, select Change.
3
In the Operation Mode field, select NAT/Route.
4
Select OK.
The FortiGate unit changes operation mode.
5
To reconnect to the web-based manager, you must connect to the interface
configured by default for management access.
By default in NAT/Route mode, you can connect to the internal interface. The default
internal interface IP address is 192.168.1.99.
86).
86).
01-28007-0144-20041217
Status
31
Advertisement
Table of Contents
