Routing Table (Transparent Mode); Routing Table List - Fortinet FortiGate FortiGate-60 Administration Manual

System network

Routing table (Transparent Mode)

Routing table list

FortiGate-60 Administration Guide
You can configure primary and secondary DNS server addresses, or you can
configure the FortiGate unit to obtain DNS server addresses automatically. To obtain
addresses automatically, at least one interface must use the DHCP or PPPoE
addressing mode. See
If you enable DNS Forwarding on an interface, hosts on the attached network can use
the interface IP address as their DNS server. DNS requests sent to the interface are
forwarded to the DNS server addresses you configured or that the FortiGate unit
obtained automatically.
Figure 11: DNS
Obtain DNS server
address automatically
Primary DNS Server
Secondary DNS Server Enter the secondary DNS server IP address.
Enable DNS
forwarding from
To add DNS server IP addresses
1 Go to System > Network > DNS.
2 Change the primary and secondary DNS server IP addresses as required.
3 Select Apply to save the changes.
In Transparent mode, you can configure routing to add static routes from the
FortiGate unit to local routers.
Figure 12: Routing table
"DHCP" on page
When DHCP is used on an interface, also obtain the DNS server IP
address. Available only in NAT/Route mode.
Enter the primary DNS server IP address.
Enable the check boxes of the interfaces to which DNS Forwarding
applies. Available only in NAT/Route mode.
01-28006-0002-20041105
Routing table (Transparent Mode)
46. See "PPPoE" on page 47.
57