Changing Unit Information - Fortinet FortiGate FortiGate-60M Administration Manual
Version 2.80 mr7 antivirus firewalls
Hide thumbs
Also See for FortiGate FortiGate-60M:
- Quick start manual (2 pages) ,
- Installation manual (64 pages)
Table of Contents
Advertisement
System status
Changing unit information
FortiGate-60M Administration Guide
Figure 3: Sample system resources history
History
The history page displays 6 graphs representing the following system resources and
protection:
CPU Usage History
Memory Usage History Memory usage for the previous minute.
Session History
Network Utilization
History
Virus History
Intrusion History
Recent Intrusion Detections
Time
The time at which the recent intrusion was detected.
Src / Dst
The source and destination addresses of the attack.
Service
The service from which the attack was delivered; HTTP, FTP, IMAP,
POP3, or SMTP.
Attack Name
The name of the attack.
Administrators with system configuration write access can use the unit information
area of the System Status page:
•
To change FortiGate host name
•
To update the firmware version
•
To update the antivirus definitions manually
•
To update the attack definitions manually
•
To change to Transparent mode
•
To change to NAT/Route mode
01-28007-0144-20041217
CPU usage for the previous minute.
Session history for the previous minute.
Network utilization for the previous minute.
The virus detection history over the last 20 hours.
The intrusion detection history over the last 20 hours.
Status
29
Advertisement
Table of Contents
