Networks List - Fortinet FortiGate FortiGate-60M Administration Manual

RIP

Networks list

150
Route-map
Static
Metric
Route-map
To configure RIP general settings
1 Go to Router > RIP > General.
2 Select the default RIP Version.
3 Change the Default Metric if required.
4 Select Enable Default-information-originate if the configuration requires advertising a
default static route into RIP.
5 Only change the RIP timers if required.
RIP timer defaults are effective in most configurations. All routers and access servers
in the network should have the same RIP timer settings.
6 Select Apply.
To configure RIP route redistribution
1 Go to Router > RIP > General.
2 Select Connected or Static or both.
3 Enter the Default Metric to be used for the redistributed routes.
4 Select a Route-map name.
5 Select Apply.
Identify the networks for which to send and receive RIP updates. If a network is not
specified, interfaces in that network will not be advertised in RIP updates.
Figure 59: RIP Networks list
Create New Add a new RIP network.
IP/Netmask The IP address and netmask for the RIP network.
The Delete, and Edit icons.
Enter the name of the route map to use for the redistributed connected
routes. For information on how to configure route maps, see
list" on page 159.
Advertise routes learned from static routes.
Enter the metric to be used for the redistributed static routes.
Enter the name of the route map to use for the redistributed static routes.
For information on how to configure route maps,
page 159.
01-28007-0144-20041217
Router
"Route-map
"Route-map list" on
Fortinet Inc.