Syslogd Setting - Fortinet FortiGate FortiGate-60M Administration Manual

Log & Report

syslogd setting

FortiGate-60M Administration Guide
log fortilog setting command keywords and variables (Continued)
Keywords and
variables
psksecret
<str_psk>
server
<address_ipv4>
status
{disable | enable}
Note: The IPSec VPN settings for the FortiGate unit must match the VPN settings on the
FortiLog unit.
Example
This example shows how to enable logging to a FortiLog unit, set the FortiLog IP
address, add a local ID, and add a pre-shared key for an IPSec VPN tunnel.
config log fortilog setting
set status enable
set server 192.168.100.1
set localid net_host_c
set psksecret J7fram54AhTWmoF5
end
This example shows how to display the log setting for logging to a FortiLog unit.
get log fortilog setting
This example shows how to display the configuration for logging to a FortiLog unit.
show log fortilog setting
If the show command returns you to the prompt, the settings are at default.
Note: The only command keyword for syslog setting that is not represented in the web-
based manager is the facility keyword.
Use this command to configure log settings for logging to a remote syslog server.
You can configure the FortiGate unit to send logs to a remote computer running a
syslog server.
Command syntax pattern
config log syslogd setting
set <keyword> <variable>
01-28007-0144-20041217
Description
Enter the pre-shared key for the IPSec
VPN tunnel to a FortiLog unit. You can
create an IPSec VPN tunnel if one or more
FortiGate units are sending log messages
to a FortiLog unit across the Internet. Using
an IPSec VPN tunnel means that all log
messages sent by the FortiGate are
encrypted and secure.
Enter the IP address of the FortiLog unit.
Enter enable to enable logging to a
FortiLog unit.
CLI configuration
Default Availability
No All models.
default.
No All models.
default.
disable All models.
355