Mode Switch Bank Settings and Optional Installations
This appendix covers the following items:
•
"Required Tools" on page B‐1
•
"Setting the Mode Switches" on page B‐1
•
"Memory Locations and Replacement Procedures" on page B‐3
REQUIRED TOOLS
Use the following tools to perform the procedures provided in this appendix:
•
Antistatic wrist strap
•
Phillips screwdriver
SETTING THE MODE SWITCHES
Figure B‐1 through Figure
settings for normal operation. These switches are set at the factory to the off position and
rarely need to be changed.
Caution: An antistatic wrist strap is required to perform the procedures in this appendix.
Use the antistatic wrist strap shipped with chassis when performing any of the procedures
in this appendix to minimize ESD damage to the devices involved.
Precaución: Para llevar a cabo los procedimientos especificados en el apéndice deberá
utilizar una pulsera antiestática. Para realizar cualquiera de los procedimientos
especificados en el apéndice, no olvide utilizar la pulsera electrostática que acompaña el
chasis para minimizar los efectos de las descargas de electricidad estática.
Caution: Read the appropriate sections to be fully aware of the consequences when
changing switch settings.
Only qualified personnel should change switch settings.
Precaución: Si desea modificar la configuración del interruptor, lea las secciones
correspondientes para saber cuál será el resultado de hacerlo.
Estas modificaciones a la configuración sólo debe realizarlas personal calificado.
B‐3 show the location of the mode switches and the switch
Enterasys Matrix DFE-Platinum Series Hardware Installation Guide
B
B-1