3.10 Completing The Installation - Enterasys Matrix E1 1G587-09 Installation Manual

RJ45
Pin
1
2
4
5
6
8

3.10 COMPLETING THE INSTALLATION

After installing the 1G58x-09 and making the connections to the network, secure the cables by
running the cables along the strain-relief bracket and tying them to the strain-relief bracket using
cable ties.
Initial Logon to Device Management
You can now logon to the 1G58x-09 via the Console port and configure it using the command line
interface (CLI). To initially access device management from your local pc, terminal, or modem
connection, proceed as follows:
1. Enter rw (Read-Write) for Username.
2. At the Password prompt, press ENTER (RETURN).
For details on how to configure the 1G582-09 using the command line interface, refer to the
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide. The CLI commands enable you
to initially set up and perform more involved switch management configurations.
Modem Port Adapter Wiring and Signal Diagram
Conductor
Blue
Orange
Red
Green
Yellow
Gray
DB25
Pin Signal
2 Transmit (TX)
8 Data Carrier Detect (DCD)
3 Receive
7 Ground (GRD)
20 Data Terminal Ready (DTR)
22 Ring Indicator
Completing the Installation
Hardware Installation 3-35