Lacp Port Setting - D-Link xStack DES-3800 Series User Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
After setting the previous parameters, click Apply to allow your changes to be implemented. Suc-
cessfully created trunk groups will be show in the Current Link Aggregation Group Entries table as
seen in Figure 6-8.

LACP Port Setting

The LACP Port Setting window is used in conjunction with the Link Aggregation window to create
port trunking groups on the Switch. Using the following window, the user may set which ports will be
active and passive in processing and sending LACP control frames.
82